omghanners
Pin Clutch Remover - Mystery Color - LAST CHANCE
Pin Clutch Remover - Mystery Color - LAST CHANCE
Couldn't load pickup availability
MYSTERY COLOR - ITEM COLOR WILL VARY
Have a lot of enamel pins to put on backing cards?
Do these pins also happen to have rubber or plastic clutches?
If you answered yes to both questions, this tool can help you make short work out of that pile of pins!
Just slide the pin along the top surface with the backing posts lined up in the channel and the tool will gently pull the clutches off the backing posts and drop them in the integrated collection bucket.
Q&A
Q: Can I have a specific color?
A: If I happen to have that color on hand, yes. The colors currently on hand are: gray, purple, yellow, and white as well as a few blue and green. No refunds or exchanges if you don't receive the color you were hoping for.
Q: Does this work with pins that have metal clutches?
A: No, metal clutches generally have a butterfly locking mechanism that prevents it from being removed without pinching the internal metal tabs.
Q: Does this support pins with multiple clutches?
A: Yes, this tool works equally well for single and dual clutch pins.
Q: How many clutches does the integrated collection bin hold?
A: The standard size bin holds approximately 80, and the jumbo one approximately 330
Q: Is there a minimum/maximum pin size that can be used?
A: Any size pin will work. However, it may be a bit more difficult to use if the pin is smaller than 0.75"/20mm
Q: What is this made out of?
A: PLA
Dimensions
Pin puller: 1" x 0.6" x 6" (25x15x154mm)
Standard bin: 1.1" x 1.2" x 5" (29x30x155mm)
Jumbo bin: 2" x 2.5" x 5" (51x63x155mm)
Minimum clutch diameter: 0.2" (5.3mm)
Maximum clutch diameter: 0.65" (16mm)
Share




